VTE(4) BSD Kernel Interfaces Manual VTE(4)NAMEvte — Vortex86 RDC R6040 Fast Ethernet driver
SYNOPSIS
vte* at pci? dev ? function ?
Configuration of PHYs is necessary. See rdcphy(4).
DESCRIPTION
The vte device driver provides support for RDC R6040 Fast Ethernet con‐
troller which is commonly found on Vortex86 System On a Chip (SoC).
The RDC R6040 has integrated 10/100 PHY for 10/100Mbps support in full or
half-duplex. The controller supports interrupt moderation mechanism, a
64-bit multicast hash filter, VLAN over-size frame and four station
addresses. The vte device driver uses three station addresses out of
four as perfect multicast filter.
SYSCTL VARIABLES
The following variables are available
hw.vte.vte<x>.int_rxct
Maximum number of packets to fire RX completion interrupt. The
accepted range is 0 (disable interrupt moderation) to 15, the
default is 0.
hw.vte.vte<x>.int_txct
Maximum number of packets to fire TX completion interrupt. The
accepted range is 0 (disable interrupt moderation) to 15, the
default is 0.
SEE ALSOifmedia(4), mii(4), netintro(4), vlan(4), ifconfig(8)
DM&P Electronics Inc. Vortex86, http://www.dmp.com.tw.
HISTORY
The vte driver was written for FreeBSD by Pyun YongHyeon
⟨yongari@FreeBSD.org⟩ and ported to NetBSD by Manuel Bouyer
⟨bouyer@NetBSD.org⟩. The vte device driver first appeared in NetBSD 6.0.
BSD January 23, 2011 BSD