MOPPROBE(1) BSD General Commands Manual MOPPROBE(1)NAMEmopprobe — MOP Probe Utility
SYNOPSISmopprobe-a [-3 | -4]
mopprobe [-3 | -4] interface
DESCRIPTIONmopprobe prints the ethernet address and nodename of MOP SID message on
the Ethernet connected to interface or all known interfaces if ‘-a’ is
given.
OPTIONS-a Listen on all the Ethernets attached to the system. If ‘-a’ is
omitted, an interface must be specified.
-3 Ignore MOP V3 messages (Ethernet II).
-4 Ignore MOP V4 messages (Ethernet 802.3).
SEE ALSOmopchk(1), mopcopy(1), moptrace(1), mopd(8)AUTHORS
Mats O Jansson ⟨moj@stacken.kth.se⟩
BSD October 2, 1995 BSD