IPX_CMD(8)IPX_CMD(8)NAMEipx_cmd - bridge between Novell's SCMD driver and local IPX network
SYNOPSISipx_cmd-A server name [ -l local interface name ]
DESCRIPTIONipx_cmd moves packets from tapN to server and vice versa. It is some‐
thing like IPX Tunnel, but it uses Novell Netware 5 server Compatibil‐
ity Mode Driver (AKA Migration Agent) on the other end of wire. You
must first configure your kernel tapN device with IPX EthernetII frame
and with network number set up on server (you can use kernel autodetec‐
tion).
OPTIONS-A server name
This is IP name of compatibility mode server. You can use DNS
name or dotted quad to specify server address.
-l local interface name
This allows you to specify, which of your IP addresses should be
used as IP address of client side of CMD driver. You must con‐
figure your tapN device with hardware address 7E:01:AA:BB:CC:DD,
where AA:BB:CC:DD is your IP address in hexa.
EXAMPLE
If you are on server platan.vc.cvut.cz (147.32.240.81) and your migra‐
tion agent runs on server boris.vc.cvut.cz, you can configure your sys‐
tem with:
insmod ethertap
ifconfig tap0 hw ether 7E:01:93:20:F0:51 up
ipx_interface add -p tap0 EtherII
ipx_cmd-A boris.vc.cvut.cz -l 147.32.240.81 &
BUGS
This program was written to satisfy my own needs and should be really
improved. At least it should configure tap interface itself.
AUTHOR
Petr Vandrovec <vandrove@vc.cvut.cz>
ipx_cmd IPX Utilities IPX_CMD(8)